Latest activity

I'm not having problems with the deck belt, it's been changed before with no problem. It's the belt from the PTO to the deck drive...

I learned when I did my Z-Force 48" deck belts that the PTO belt can easily fit on the wrong side of the deck idler and tensioner. The...

Again, thank you for your attention, info, and suggestions. I would have no idea what a compression-relief engine is if I hadn't just...

You stored it without any gas, but did you run the fuel completely out of the carburetor as you stored it?

Hi Forest#2, The OP is working on a B&S twin not an Onan, but it is good information to know. I occasionally see Onan generators in...

Deck drive belt should come off the left side of the center spindle pulley, go to the right of the flat pulley behind the center spindle...

Cut height around 3". I'm not sure of height of grass before cutting. The Bermuda isn't that tall, 4" or so. But the other stuff, native...

Hello kmills74, If you have a good compression tester, make sure the Shrader valve is snug in the tip of the hose and use the...

Hi Tiger SE, I think we both know "common sense" is not common anymore. I grew up in a poor family where we had to keep everything...

Bought mine new in 2011 and have 544 hours on it and mow about 1 1/2 acres each mowing. Two belt changes is all I've ever had to do...

My factory manual and everyone I've downloaded to check, shows deck belt routing but not the PTO routing. The link sgkent gave, did...

for what it's worth, my soil condition is sandy loam, and the deck bearings on my Gravely were burning out about every 3 months or 30...

Hi Forest#2, The OP is working on a B&S twin not an Onan, but it is good information to know. I occasionally see Onan generators in...

this is termed waste spark ignition. normally when a plug wire is purposely pulled the Onan waste spark ignition engine will not run on...

As was stated earlier, better to remove plug, insert into plug cap, and ground the plug to discharge energy via spark.