Latest activity

Apparently you will have to drill holes in bottom plate so you can hold brushes in with a couple of wires. It is a real pain.

You Have to make 4- square bottom "U" shaped stiff wire clips to hold the brushes back and allow them to slip past the commutator. There...

The stator only puts out AC and it’s not for Lighting. The stator puts out AC that goes to a regulator that charges it to DC to charge...

Ok if it’s wiring on the engine you need to look up the model number of the engine. If it’s wiring to the engine then use the model...

As a side, there is a great range of experience here. My guess would be with the faulty safety switch. Those experts who contribute, my...

Just now, just for Schlitz and giggles, I got the jack out of the car, jacked up the front of the Snapper, and lowered it onto the...

Those with a spacer between the 2 bearings , at minimum 1 of those 2 bearings needs to be a push fit . ie - the outer race needs to be...

Yep I have repaired many mowers that just clicked when the key was turned, installed the relay and no more just clicks. Only trying to...

Thank You. New to this so it should be fun.

Yes. Notches at either end.

Is there a spacer on the shaft between the open sides of the bearings ?

I have a 2007 -2008 Dixon Ram Ultra 60 with a bad deck spindle.so far I have been unable to find one as they are no longer availabl. I...

How old is this mower? Fuel lines deteriorate with age. They might look good on the outside but can be flaking off on the inside. Trash...

I saw the video using u shaped pieces but there is no holes to put them in to hold the brushes in.

Thanks for your suggestion. I'm going to try the gas cap trick first. I'll add this as a possible cause if it's not the gas cap and/or...