Latest activity

The next possibility is debris floating around in the fuel tank and blocking the fuel pickup tube. That or the fuel shutoff solenoid on...

The larger paper clips work good (the big star shaped ones) to make the clips or an old throttle/choke cable wire.

You Have to make 4- square bottom "U" shaped stiff wire clips to hold the brushes back and allow them to slip past the commutator. There...

I take it that this is a fuel injected model?

he says the voltaqes are good and the battery good too. I asked because that is the most common type problem but hey, if he is only...

Have you resolved this problem yet? Just checking.

You will have to remove the PTO center bolt an slip the PTO off. It may have to come apart to get the belt material out of it.

You Have to make 4- square bottom "U" shaped stiff wire clips to hold the brushes back and allow them to slip past the commutator. There...

Sounds like the starter gear is upside down or the wrong tooth count on the gear.

if that is while cranking it is excellent or indicates resistance between it and the starter, ground etc.. If that is just sitting it...

Always check valves before flywheel key. Rarely is it a sheared flywheel key, but you should be surprised how often something wrong is...

I had spindle go bad, very bad s shredded the belt, string from the belt is caught up in my PTO and binding it up. How do I remove the...

I did see some of Jim's videos and quite a few others. I did find a Briggs manual and got a few ideas from that as well. It just took a...

Again, thank you to everyone. I wound up having to use wax, wd40, ATF, Blaster, propane, 3 lb mall, soaking over night several times...

Just now, just for Schlitz and giggles, I got the jack out of the car, jacked up the front of the Snapper, and lowered it onto the...