Latest activity

Thanks for the recommendation. I actually ordered the one I posted but am thinking of getting a second one to compare readings, as...

I like your thinking here and I may do just that. I can always return one (or both)

They are far from precision tools. If cheap enough, purchase two & compare the reading. 😈

What do you think, the engine wants? If you spray go-go juice and she runs for a bit, then dies......... Did you clean the fuel tank...

I have a Toro commercial mower 74180 and went to change the spark plugs. The rear plug was annoying enough because I had to remove...

That is incredibly helpful - thanks!!

Maybe this will help if you enlarge the page view...

Once the cutter spool is installed, you pull the loose end out of the (temporary) holding groove through the outer hole so it can feed...

I've worked small engine equipment since I was a very young man, and it has always been a backup source of income for me. There is not...

Thanks, I looked at those, there is one on each side. I'm going to look at those to see if they may be the cause of all of the slack...

I'll take another look - not seeing anything red in the photo, but where I see the cord inserted at the top of the photo isn't where I...

I think so - it looks like the natural direction for the feed.

I checked outthe 8-ten kits for my mower that's an awful lot of stuff compared to what I just paid for a single OEM Mandrel Ass'y. For...

Replaced deck pullies, spring, new wheels and blades. Belt still twists at the engine pully then goes back normal but it's chewing up...

Hello oldntired55, I came across some recently where the new deck spindle makers installed a tight fit pipe spacer to set the distance...