Latest activity

Hi dinows, Older mowers like your previous simple design Murray had practically no safety switches. I think people had more sense to...

roughly 15 years ago, on an older Craftsman rider i had , i took the spindles apart... removed the inner seals.. and drilled and tapped...

Cheap ain't good and good ain't cheap. If you are going to buy one, get one that's a little more expensive. Look for one that only gives...

Most newer riding mowers that aren’t ultra cheap have foot pedal forward and reverse control.

You take the wife's best big sharpest kitchen knife and place the sharp edge on which side of the gasket you like . Then you use the...

there should be a total of 7 bolts/studs holding the sump on. Check down those deep hole above and below the crankshaft. I think you...

Before doing anything more remove the key and bolt. Then take some medium/fine abrasive paper and polish the crankshaft until it is...

Take a heat gun and run it around the two halves of engine case where gasket is.

I went back and studied the picture for your spool with the cutter string on it. The starting tip of the string is inserted into the...

My neighbor just bought a John Deere that has the foot control but every time you go in reverse you have to disengage the blade, not so...

Most newer riding mowers that aren’t ultra cheap have foot pedal forward and reverse control.

Take a heat gun and run it around the two halves of engine case where gasket is.

They are far from precision tools. If cheap enough, purchase two & compare the reading. 😈

Anyone that sends back $10 parts that don’t work for a refund needs to seriously reevaluate life.

Are you sure you are rapping the string in the right direction? I did this on one of my trimmers and the auto feed wouldn't work. Just a...