Latest activity

Chinese

No, I did remove it to clean and make sure rust was not interfering with the ground. Would a coil act up on slower RPM? I also pulled...

Not likely governor. More likely new carb not acting correctly. But being a Courage single don't overlook the gasket behind the black...

kohler sv600-0009 engine surges when the throttle is at half position and below, at full throttle no problem. when choke pulled out at...

Sorry, steering damper. https://www.gravely.com/en-us/part/gravely-zero-turn-mower-damper-00188700 But my gosh it looks like they have...

Husqvarna or Cub Cadet

These were an innovative take on the earlier Snapper rear engine riders in my opinion. This is a 30-year-old mower that only a diehard...

I’ll check compression tomorrow if I get a chance. I’ll also do a leak down test if I can find my setup. I start working harvest late...

Good, sounds like you have been diligent in your efforts to maintain this. That leaves the breather as a suspect or piston and ring...

I clean the cooling fins every time I use it. I got it from my brother in law when it us 18 hours on it I change the oil every 25 hour...

I think your trimmer string is too thick of a diameter for this trimmer. There should be a spring in the middle that is not shown in...

Were the cooling fin heat shields left off when you did the overhaul? They must be in place to get force air from the flywheel colling...

This whole thing is pointing at overheating due to excess debris in the cooling fins or a bad crankcase breather from the very...

This whole problem is pointing at overheating due to excess debris in the cooling fins and or a bad crankcase breather from the very...

try this Using a sprinkler about 3/ 4 inch tall , so the blades don't contact it , put it under the deck and at full throttle run the...