Latest activity

It would really help if we had the model, type, and code from the engine so we could see what your engine looks like. A 140cc engine...

what was it?

Hi Scrubcadet10, Only (most) independent operators know what they are doing these days because they grew up working on this equipment...

Hi Skippydiesel, What's bad about these is people using (abusing) these funnels is when they think they will rejuvenate old, oxidized...

Past time to: 1.Pull engine shroud and clean the cooling fins. (should be done yearly if not sooner) 2.De-carbon the cylinder/s...

So far i have replaced the carburetor, ensured rubber hose from gas tank to carburetor is clear and clean. I also cleaned out fuel tank...

Just a plain small Craftsman flat blade usually works well. It may need the sides of the tip filed or ground slightly...

Hello gadindixie, When you post a help request, we need the stamped number information in the valve cover of your "17.5 briggs". They...

Hi Skippydiesel, What's bad about these is people using (abusing) these funnels is when they think they will rejuvenate old, oxidized...

Sounds good. Appreciate the feedback. Take care and thank you.

Hi I can't get a spark. Any help please The coil resistance is reading 15 on 200k setting on multi-meter It was working fine last...

Ever had a case where all the engines were working one day then after a storm have 5 coils failures the very next day? So glad they...

Thanks for the reply & suggestion. I’ll go over it again & the belt routing.

You must of missed something in the belt routing or a pulley has fallen off.

Check blade brakes.