Latest activity

Cub Cadet Website using model ZTX4-60 KH FAB (47ASAAA8010) (2021) (ULTIMA ZTX4). Then look spindle assy diagram. The bearings are...

If you really want to get a puzzled look on their face, ask them to bring in the missing parts so you can weld each of them back...

Well, it turned out to be the damn battery. I charged it all day and it started. I was able to cut the grass but when I shut it down and...

Check the wiring diagrams. You will need the model number and serial number to find them.

"I just need this sharpened"

I have a bad scar in my shin caused by a push mower blade fragmenting like one of these shown. People don't realize that checking and...

If you really want to get a puzzled look on their face, ask them to bring in the missing parts so you can weld each of them back...

All, this is a delayed update. To last years issue but had to make sure the fix lasted. So, I took the advise to replace the bolt and...

Update: Here are the plugs after 4 hours on a new carb and two new ignition coils. Plugs in same position as before.

hlw49 I'm done w/ TDC wasted about 4 hours. I managed to adjust the valves lower valve set to .004 top valve .006 she did crank up. I...

This thing has already been through the 2.3 gallon 6 transducer ultrasonic cleaner for 2 30 minute cycles, plus had all the passages ran...

Thanks for that good info ! Where does that diagram come from ? "... the spacers on each end" ; would that be #8 on top and #11 on...

Spraying around intake manifold gaskets does nothing. Spraying into the carb causing a rich run. I have since discovered posting...

Watch the video. Engine has to be on top dead center on the compression stroke to adjust the valves.

I have a bad scar in my shin caused by a push mower blade fragmenting like one of these shown. People don't realize that checking and...