You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
valve adjust
- Thread starter cambre
- Start date
I took the head off of a 5hp Honda to free up a stuck valve. Valve adjustment is .0015 to .0020. This seems pretty loose to me. Is this correct. Thanks
I think I used wrong feeler gauge. I used .015 instead of .0015. Must be getting old or blind.
bertsmobile1
Lawn Royalty
And double check the specs as Honda generally use mm for valve lash not inches.
And double check the specs as Honda generally use mm for valve lash not inches.
Thanks bertsmobile1: I will do that. Hope all is well in Australia.
Thanks bertsmobile1: I will do that. Hope all is well in Australia.
I think I got the right valve spects now, intake .006 +/- .001, exhaust .008 +/- .001. Thanks bertsmobile1
My 5.5 HP is 0.15 mm and 0.20 mm respectively.
Thanks Ripleyx19. I replied to your earlier but it didn't send. I set the valves .006 intake and .008 exhaust. Almost the same as the mm setting and with .001 leeway its the same.