Troy-Bilt 700 series 42" deck extension springs problem

[kapkaine@yahoo.com]

I was replacing my pulley spindles when I must have removed the two extension springs. Now two weeks later (waiting for the parts) I've forgotten where the two extension springs are connected to. The parts diagram on Troy-Bilt's manual is not very helpful, and I've not been able to locate a good picture/diagram online. Next to going to Lowes and lying on the floor to look @ one, I'm out of ideas. Any help out there would greatly appreciated.

 

[ILENGINE]

Sometimes but not always, MTD will have spring connect location on there parts diagrams. It will look like a line going to the end of a spring with the letter A, and then someplace else on the diagram it will have that same line with the letter A Without knowing your full model number information I can't check the diagram myself.

 

[kapkaine@yahoo.com]

Thanks, I'll check that out.