Export thread

tractor won't start

#1

4

451johnny

hi I have a Husqvarna yth 20-42 that won't start I've used clean gas I cleaned the plugs I've changed the fuel pump because the one it had wasn't working I replaced the carburetor.. it cranks good and only start for a second or two when I use starter fluid..it does not have a deck hooked up to it but I don't think that has anything to do with it..?? help pleaseeee johnny


#2

M

mechanic mark

fresh gas, fresh air, spark & compression are needed for start up.


#3

4

451johnny

fresh gas, fresh air, spark & compression are needed for start up.
it has all that I forgot to mention that the day before after replacing the carburetor it started just fine I let it run for about ten minutes then turned it off and the next day I tried and it just cranked ..starts now for a second or two with starter fluid ??


#4

B

bertsmobile1

Check the cut off solenoid on the carb.
Check the wire is in all the way and if you have a 2 wire plug check that the ground wire is actually grounding.
You can go whole hog, pull it off & check it is opening when the key is on.
Over time the insulation at the plug pulls back & the wires short or break


#5

4

451johnny

Check the cut off solenoid on the carb.
Check the wire is in all the way and if you have a 2 wire plug check that the ground wire is actually grounding.
You can go whole hog, pull it off & check it is opening when the key is on.
Over time the insulation at the plug pulls back & the wires short or break

GREAT.. WILL DO AND I'LL GET BACK TO YOU ..CROSSING MY FINGERS


#6

4

451johnny

Check the cut off solenoid on the carb.
Check the wire is in all the way and if you have a 2 wire plug check that the ground wire is actually grounding.
You can go whole hog, pull it off & check it is opening when the key is on.
Over time the insulation at the plug pulls back & the wires short or break

thank you so so much it turned out the fuel solenoid wasn't getting power ..I had wired it wrong ..again thank you johnny


#7

B

bertsmobile1

Excellent news.
The 2 pin plug is supposed to have a handed plug but as you have noticed, not particularly well done.


Top