Export thread

Toro Timecutter 420 Hydro issue

#1

K

KATFISHER

The LH hydro will quit pulling after about 30 min of running. Any suggestion on solving? If need to replace-- cheapest place?


#2

C

chance123

Unfortunately those hydros are not servicable. Your discription is classic for failure and end of life for that pump/motor


#3

Carscw

Carscw

The LH hydro will quit pulling after about 30 min of running. Any suggestion on solving? If need to replace-- cheapest place?

Pull the motor off and take it to a hydro shop and they will rebuild it.
If not sure where a shop is go to napa

(( racing is the only sport that you need two balls ))


#4

K

KATFISHER

Unfortunately those hydros are not servicable. Your discription is classic for failure and end of life for that pump/motor

Thanks for the reply.


#5

C

chance123

Thanks for the reply.

I have tried to get them rebuilt, but the cost for rebuild vs a new one, was a no brainer. I think for $20.00 more than a rebuild, you can get it new.


#6

Carscw

Carscw

I have tried to get them rebuilt, but the cost for rebuild vs a new one, was a no brainer. I think for $20.00 more than a rebuild, you can get it new.

I see your point. I would spend the extra $20.

My pumps on my sand dredge run $1200
I get them rebuilt for $200.

Don't know what a new one on a mower goes for

(( racing is the only sport that you need two balls ))


#7

C

cob48

The LH hydro will quit pulling after about 30 min of running. Any suggestion on solving? If need to replace-- cheapest place?

I have had that same problem, I just add hyd oil to the gear box and it works fine for a month or two


Top