Export thread

Tilted side to side 2"

#1

D

Donjeere

How did my 54" deck on JD 345 end up 2" higher (or lower) from side to side? Don't remember hitting anything.


#2

BlazNT

BlazNT

While you are mowing your deck is being bounced up and down all the time.


#3

B

bertsmobile1

And vibrations can cause welds to break.


#4

D

Donjeere

BlazNT said:
While you are mowing your deck is being bounced up and down all the time.
Click to expand...

Doesn't appear so. I've had tractor since new 1999. The deck was new 3-4 yrs ago. Was working fine. I just cranked up nut to lift assembly to where I've got same clearance to ground on both sides at this time. Next mowing session I will see what I've got then, I guess. Thanks for your inputs!
Sjb


#5

D

Donjeere

bertsmobile1 said:
And vibrations can cause welds to break.
Click to expand...

Welds appear solid.
Thanks!
Sjb


#6

S

shiftsuper175607

Donjeere said:
How did my 54" deck on JD 345 end up 2" higher (or lower) from side to side? Don't remember hitting anything.
Click to expand...

There is a "J" shaped pin that supports the back on each side...make sure it is in place in the hole on the low side


#7

D

Donjeere

Donjeere said:
Doesn't appear so. I've had tractor since new 1999. The deck was new 3-4 yrs ago. Was working fine. I just cranked up nut to lift assembly to where I've got same clearance to ground on both sides at this time. Next mowing session I will see what I've got then, I guess. Thanks for your inputs!


Sjb[/QUOTE

Update: above adjustment apparently made difference !! Thanks for all input!,
Sjb
Click to expand...


Footer Links 1

Top