I put a new battery in, and PTO clutch on my Snapper LT16002 and had wires getting hot after it ran for about 5 minutes. Decided to replace the key switch, PTO switch, headlight switch and solenoid since all were at least 20 years old. When I got into doing the replacement I noticed that the doide #7023235 was fried to the point of the wire end broken apart. Obviously this is not right! My question is......is there another diode that can be used in place of the $32 OEM one? Anyone know what amperage and voltage diode is required?
Thanks!
Thanks!
Last edited: