Export thread

I need a mower deck for the above tractor.
I believe this tractor was built by Murray.
The two Sears part numbers I have are 327452 and 377452. Sears says these are obsolete.
Would anyone happen to know of a replacement or cross reference part number?

Ebay has new deck shells for about $150.00 and some sellers have free shipping . Just swap over your pulleys/blades .

SONOFADOCKER said:

Ebay has new deck shells for about $150.00 and some sellers have free shipping . Just swap over your pulleys/blades .

Click to expand...

Lots of luck on this finding the right deck that fits. I am going to say go to a mower salvage yard and still its going to be hard to find one that isn't all rusted out. Also I can see a lot bigger cost then 150 dollars. I find mower parts are very $$$. Just remenber you can buy a new rideing mower for about 1000 dollars so don't get too carried away on a new deck.

$169.99 for 42 inch deck free shipping .

gadkins said:

I need a mower deck for the above tractor.
I believe this tractor was built by Murray.
The two Sears part numbers I have are 327452 and 377452. Sears says these are obsolete.
Would anyone happen to know of a replacement or cross reference part number?

Click to expand...

I have the same model no. tractor 535.255870. mine is a 43'' deck. just curious what inch is on yours ??.. I personally have never seen nor heard of a 43''. they all seem to be 42'' 44'' 46'' and so on in the even numbers . its also 15 hp with 4 wheel steering....? is this the same tractor you have?

davefileccia said:

I have the same model no. tractor 535.255870. mine is a 43'' deck. just curious what inch is on yours ??.. I personally have never seen nor heard of a 43''. they all seem to be 42'' 44'' 46'' and so on in the even numbers . its also 15 hp with 4 wheel steering....? is this the same tractor you have?

Click to expand...

I also have the same model, and yes, mine is a 43-inch deck as well. I'm also looking for a new deck, as the area where the bolts attach the deck to the height adjusters has rusted through. If you find one, please let us know where.

Hey, you guys. Hod rodders routinely cut out rusted floor pans and reweld replacements. Maybe this can be done? It seems you may be facing some "precision" geomtery if spindles etc are involved. Anyway, if you've tried this or done it let's hear....:anyone: