Good Day!! I was just wondering if anyone has found a place to buy the friction material to reline the mower clutch? we used to do this on the old dragline cranes and dump trucks. A new Warner (non China) one is about 300 bucks. So this is just a thought.
Good Day!! I was just wondering if anyone has found a place to buy the friction material to reline the mower clutch? we used to do this on the old dragline cranes and dump trucks. A new Warner (non China) one is about 300 bucks. So this is just a thought.
If this is a rider mower electric clutch, they do not have linings on the faces. They a magnetic pull in steel face clutch design like an A/C compressor on an older vehicle.
As they wear the air gap does get too wide for the coil magnet to pull in the drive plate.
