Old Woman in Comfortable Shoes

spirittoo2000

Forum Newbie
Joined
Nov 21, 2026
Messages
5
I have the ferris 400s 5901705 zero turn ... I am here to find out why after changing the transmission on it won't go in a a reasonable rate. There doesn't seem to be much activity here so I'm not sure I can get help but I shall see.
 
A few questions. Was the new transmission properly purged of air. Is the drive belt for the transmissions tight and turning the drive pulleys on the transmissions. Make sure the bypass isn't engaged which will prevent the mower from driving.
 
I have the ferris 400s 5901705 zero turn ... I am here to find out why after changing the transmission on it won't go in a a reasonable rate. There doesn't seem to be much activity here so I'm not sure I can get help but I shall see.
The Ferris 400s is equipped with dual Hydro Gear 2800 trans axels. Your post does not make it clear what the zero turn is and is not doing? Does it move? Does it make noise? What was done, a service, a full rebuild?
 
And did you install the correct gear ratio ZT-2800?

There are three different gear ratios.
1795350360213.png
 
A few questions. Was the new transmission properly purged of air. Is the drive belt for the transmissions tight and turning the drive pulleys on the transmissions. Make sure the bypass isn't engaged which will prevent the mower from driving.
That is what I am working on ... I've been working to purge the air from the system ... enough oil got in to move the mower I moved the sticks back and forth for small movements ... that help purge the air. So far I was able to get the first gallon in. I continued to purge the air, but now for some reason it's not showing any air bubbles when I was moving back and forth earlier.
No bubbles no matter which way I move the sticks. I have the throttle on low during the movements. No oil will go in while the mower is shut down. I waited 10 days ... nothing.

As far as the drive pulleys ... I really can't tell ... you see I injured myself on the 9th. I tripped and fell back on my butt ... hurt my back ... wellsir I need a walker to move around. Therefore I am limited in what I can do. The only reason I am trying to get the oil in is the weather is warm and beautiful and this is Nov. I am able to be outside, best thing for me too instead of being on my back all day long. Not only that the weather is going back to cold average weather in these parts tomorrow..
 
The Ferris 400s is equipped with dual Hydro Gear 2800 trans axels. Your post does not make it clear what the zero turn is and is not doing? Does it move? Does it make noise? What was done, a service, a full rebuild?
Right now with the exception of only having half of the 2.5 gallons required it is working normally. I can run it back and forth, turns ... no problems. I can't hear any noise other than what is normal to me. I changed the transmission oil and filters. Part of the machines regular maintain.
 
I'm going nutty ... I wanted to double check the amount of 20/50W oil is required was 2.5 gal ... now I can't find it. I found one site that stated 2 quarts per side. Maybe that's why no more will go in? I need to verify the amount .:unsure:
 
Back
Top