Question regarding octane/non-ethanol....there is only one gas station in my area which has non-ethanol gas, and it is 110 octane. Is that octane too high for my yard equipment (trimmer, blower, push mower, and ZT mower)? Or would I be better off just using a stabilizer with the regular gas?
I use regular hi-test gas with stabilizer and don't keep a ton of gas on hand so it tends to stay "fresher"
Tom
#3
tom3
Depends some on the octane calculation method, but real 110 R+M octane would probably burn up something I'd think. Seem motorcycle chrome exhaust turn blue from the heat with aviation gas with the high octane. I'd stick with what the OEM calls for with that machine.
#4
cpurvis
Using higher than specified octane will not hurt anything, other than your gas mileage. Higher octane fuel weighs less per gallon than low octane fuel. Since we buy fuel by the gallon but burn it by the pound, it doesn't go as far as fuel that weighs more per gallon. I don't think this will be an issue with a lawn mower.
Higher octane gas is meant to be used in engines with higher compression. Higher octane gas is harder to ignite, hence less likely to pre-ignite or detonate ("ping" or "knock").
Running an engine meant for high octane gas on low octane fuel can be done if you restrict the amount of power the engine can produce. This is common among users of old radial engine aircraft.
I hear all sorts of rubbish about high octane fuels destroying engines and it is garbage.
Octane rating is simply a measure of the knock sensitiviity of the fuel.
Worst case is you are paying for a fuel that the engine can only partially burn because your compression ratio is not high enough.
Most high octane fuels do burn a little slower so can cause the exhaust to run a bit hotter .
Fuel management is a problem that is only going to get worse.
You can run ethanol fuels in a modern engine without problems just as long as the fuel is fresh.
It is the long term standing of the fuel that creates problems, particularly in regions with high humidity and big differences between the day time & night time temperatures.
Thanks to everyone for the responses. I know this octane debate is always discussed, I just wish we had more options for non ethanol fuel where I’m located in Annapolis MD. The non ethanol around here is super high octane or airplane fuel.
#7
Boudreaux In Eunice La.
They have some in Edge Water that's a 100 Octane at Lee airport ..........
Here's a link to all the stations in Maryland ..........
Thanks, I saw that the airport had some but didn’t realize it was 100, I thought it was around 110.
#9
Boudreaux In Eunice La.
It is a Low Lead gas though I think..... In my years of hanging out at the airports and doing some flying, most all Hanger Gas as we call it is Low Lead.....
It is a Low Lead gas though I think..... In my years of hanging out at the airports and doing some flying, most all Hanger Gas as we call it is Low Lead.....
I agree with the marinas and he is so close to a lot of them in his area ........... The link I put up is based on info put up by people and owners of gas stations.......... Bulk plants and Jobbers don't usually post where they sell NON ETHO gas to ...
This site depends on people like you and me to do it.............. I need to post another place here in my town that sells that gas also ..... We have 6 places in my town total and they sell a lot of gas everyday ...........
20 to 25 cents more per gallon...... So right now NO etho is $1.95 a gallon over here........
Thanks for the info, I think there may be a few marinas in the area, lol! I keep watching the pure gas site to see if any new stations have popped up in my area, but it does take customers’ initiative to get on the website and add the info.
