Export thread

I have a Husqvarna rz5424 zero turn I have replaced the idle tensioner pulley (due to the fact the other one broke) and replaced the drive belt put it all back together and now I have no power I can go foward and backwards but very slow I have no idea what to do

Did you pull the rods out to make it so you can push it?

Carscw said:

Did you pull the rods out to make it so you can push it?

Click to expand...

I did both and pushed both back in also checked to make sure they were engaging under the mower

Is the belt tight?

If it worked fine before you replaced parts then I would make sure the belt is right and on the right way.

I always double check even on my mowers I have put belts on for years.

Carscw said:

Is the belt tight?

If it worked fine before you replaced parts then I would make sure the belt is right and on the right way.

I always double check even on my mowers I have put belts on for years.

Click to expand...

I have it is that's what's got me stumped I went to a local shop and got a diagram then made sure it was on correctly then made sure the pulley was doing its job and it was keeping very good tension on the belt

Jtepps said:

I did both and pushed both back in also checked to make sure they were engaging under the mower

Click to expand...

Just for fun pull them both out and try it.