I am trying to replace the original traction drive cable (AM106051) which has been replaced by GX21634. The new cable is too long and does not seem to fit.
I cannot find anything that addresses this problem on the internet or John Deere DTAC. Has anyone else come across this situation?
#2
JoeM(GA)
If your old cable had "Z" bend, or an oblong end on it that a hook on the lever went through, you're also going to need the updated handle that has a round stub the new cable end fits over
Deere #GX22026, there is also a push nut needed to hold the cable, but I can't remember the #
