Export thread

Ok, so I took the carburetor off my pushmower to clean it out as it was running for only 5-10 seconds before it quit. I probably should've taken a picture of it before I took it off but I didn't think to do it for some reason. Anyway, the problem I am having is there are these 2 wires that connect to 2 of 3 holes on the top of the carburetor. I have them labeled below and I need someone to tell me which holes to connect the wires to.
Thanks In Advance!

The hard z-shaped rod goes in 3, the spring goes in 2, an arm should close the choke on the left, mounted on the air filter base.

By lookin 1 and 3 are for cables and 2 is for a spring.

Parkmower said:

By lookin 1 and 3 are for cables and 2 is for a spring.

Click to expand...

The spring go's in the same #3 hole as the linkage. Nothing go's in #2 hole.

Reynoldston, is correct, follow his directions. Nothing goes in 1 also. That is used for a different application.

Good stuff. Another reason I wish I'd found this site a couple of years ago.

#1 looks like it has something to do with the choke?