I have a HF mower jack that provides about 11" of clearance from floor to nut, enough for my 8" impact wrench to remove the blade nuts. The jack will go higher but the front wheels start rolling backwards a little, and if too much, will roll out of the jack's tire holder. Since I have a difficult time using a torque wrench because of my awkward position on the floor, I would like to increase the height of the deck by about 5" to allow use of a torque stick attached to the impact wrench. Does anyone have any suggestions to raise the mower an additional 5"? I thought about somehow raising the rear wheels some how so I can raise the front jack higher. Does this make sense? Torque setting on my blade nuts is 115 - 160 ft. lbs. and the torque stick is about 7 1/2".