Product # 960430116 03 // Model # YTH24V48LS
5/16/17 - My Clutch stopped working suddenly (part #532400008). I was just mowing along under no strain and the clutch disengaged and would not reengage. All it did was click and you could tell it was trying to turn the deck pulley but would not. Checked voltage (14.3V), switch, and ground. All is fine. Clutch works now after cooling off overnight but took it off to see it I could find anything wrong. All looks fine. Electro magnet coil reads 3.3 Ohms. Bearings feel great. The mower, bought new has 63 hours on it, garage kept, maintained extremely well. Kept very clean, only gets wet when I wash it off about once a year. My questions are:
1. Should I just go ahead and replace the clutch? Was this incident just a freak one time event or the precursor of things to come? If I do replace the clutch does anyone have a recommended brand other than Husqvarna?
2. If I should keep this clutch for a while longer what is the procedure for adjusting the gap between the pulley and the magnet?
Also,I have read on the forum that our friends and Husqvarna don't publish many shop type repair manuals but was hoping that someone may know where I could pick one up for this one. i like this mower and refuse to take it back to the dealer I bought it from for numerous reasons. A shop manual would make the job of maintaining it a little easier.
Any and all advice welcome
Thank you
ALAHusq
5/16/17 - My Clutch stopped working suddenly (part #532400008). I was just mowing along under no strain and the clutch disengaged and would not reengage. All it did was click and you could tell it was trying to turn the deck pulley but would not. Checked voltage (14.3V), switch, and ground. All is fine. Clutch works now after cooling off overnight but took it off to see it I could find anything wrong. All looks fine. Electro magnet coil reads 3.3 Ohms. Bearings feel great. The mower, bought new has 63 hours on it, garage kept, maintained extremely well. Kept very clean, only gets wet when I wash it off about once a year. My questions are:
1. Should I just go ahead and replace the clutch? Was this incident just a freak one time event or the precursor of things to come? If I do replace the clutch does anyone have a recommended brand other than Husqvarna?
2. If I should keep this clutch for a while longer what is the procedure for adjusting the gap between the pulley and the magnet?
Also,I have read on the forum that our friends and Husqvarna don't publish many shop type repair manuals but was hoping that someone may know where I could pick one up for this one. i like this mower and refuse to take it back to the dealer I bought it from for numerous reasons. A shop manual would make the job of maintaining it a little easier.
Any and all advice welcome
Thank you
ALAHusq
Last edited: