I have a Honda HR215K1 HMC Drive Shaft driven hydro-static lawnmower. The cable that attaches to the drive bail handle was not on the machine when it was given to me, and therefore the self-propelled feature was non functioning. After locating the desired parts (the cable and a spring) I proceeded to get the mower going.
However, after I took off the housing where the drive shaft and transmission is located I realized that there was no obvious place for the cable to affix to. I have spent so much time looking the mower over with a fine toothed comb and I can't figure out where the cable goes. I mean, I figured this would be a quick fix but its turning into a nightmare.
If anyone has a drive shaft driven mower with the drive bail handle cable installed that could shed some light on this issue, I would be forever be grateful. I'm a fairly mechanically inclined person, and refuse to let a machine win.
Thanks in advance to anyone's assistance.
However, after I took off the housing where the drive shaft and transmission is located I realized that there was no obvious place for the cable to affix to. I have spent so much time looking the mower over with a fine toothed comb and I can't figure out where the cable goes. I mean, I figured this would be a quick fix but its turning into a nightmare.
If anyone has a drive shaft driven mower with the drive bail handle cable installed that could shed some light on this issue, I would be forever be grateful. I'm a fairly mechanically inclined person, and refuse to let a machine win.
Thanks in advance to anyone's assistance.
