First, I was mowing and suddenly my Murray MT155-42" cut mower starting losing rpm's ,still cutting mind you, it didn't backfire, jolt or sputter just slowly lost rpm's ,i then disengaged belts, it gained a small rpm's back then went down again till it went dead about 75 feet further as I headed back to shed.It hasn't cranked since. I initially thought fuel.I checked fuel lines, ok. Checked bottom of carb with the wire harness plug on bottom, fuel ran out good. So, I thought electrical.It fires at the plug.I tried starting fluid spray, no backfires, no combustion.So I then remembered the shear pin or key at the magneto head disk thingy,lol, not sure what to call it. It seemed fine. No backfires remember. So, now Im back to my first thought of fuel.So ,I already checked fuel at carb so could it be water in fuel.And why wouldn't it even try to crank with starting fluid? Is a switch keeping it from sparking? Thanks for reading my large post.Just wanted to be thorough.