Hammermechanicman
Lawn Addict
Maybe we should start a AirCat vs Titanium thread like Ford vs Chevy or Mac vs PC. LOL.?
H3011H only runs when starter is engaged
- Thread starter fordperf
- Start date
Hammermechanicman
Lawn Addict
All the lower end Campbell Hausfeld is a zombie branded low end crap now. I have a 20gal CH compressor I bought 30 years ago. Used the heck out of it till i got the 60gal 5 hp Quincy. Still runs like new. The new stuff is asian junk on par with Harbor freight. Same for the air tools.
bertsmobile1
Lawn Royalty
Way way back I got a hydrovne compressor from a petrol station that was closing down.
One of the best items I have ever bought.
Must have had it for at least 30 years.
Very quiet very efficient.
When I started doing mowers I finally hooked it up to the 200 gallon receiving tank.
Now all that is left to do is to plumb the 12 outlets around & outside the workshop so I don't have to keep on hooking 3 hoses together .
I think it runs for about 10 minutes a week and it is so good when I have to run the 3/4" impact on overtightened blade bolts.
One of the best items I have ever bought.
Must have had it for at least 30 years.
Very quiet very efficient.
When I started doing mowers I finally hooked it up to the 200 gallon receiving tank.
Now all that is left to do is to plumb the 12 outlets around & outside the workshop so I don't have to keep on hooking 3 hoses together .
I think it runs for about 10 minutes a week and it is so good when I have to run the 3/4" impact on overtightened blade bolts.
After some PB Blaster on the rust I was able to get the blade off the mower, and then the blade holder off the blade. New blades got delivered, was sharp but not sharp enough, and naturally I couldnt find my grind stone for the drill, so that'll get handled tomorrow. The old blade is imbalanced and I'm just going to chuck it.
Last is wiring the jump/charge port, and I discovered my Weller iron is broken, because of course it is. Weller turned to crap as a brand lately. Need to find a better replacement (260W+)
Last is wiring the jump/charge port, and I discovered my Weller iron is broken, because of course it is. Weller turned to crap as a brand lately. Need to find a better replacement (260W+)
