Hi All!
I have a Toro Z5020 that has the EZT 2200 hydros. The left is weak, so I did a fluid change and it did not help anything. I have looked searched through this forum and others and was confident I could tear it down and repair it myself because of all of the useful information on here, so thank you for that! From what I understand the input shaft should come out easily after removing the seal and the clip. I have done both but I cannot get this thing to budge. Has anyone else run across this? I have tried PB blaster to loosen things up, put the pully back on the shaft, put a piece of wood against the pully and tried tapping out with a hammer with no luck. I feel like it maybe something easy I am missing? Any help is appreciated in advanced! Thanks!
I have a Toro Z5020 that has the EZT 2200 hydros. The left is weak, so I did a fluid change and it did not help anything. I have looked searched through this forum and others and was confident I could tear it down and repair it myself because of all of the useful information on here, so thank you for that! From what I understand the input shaft should come out easily after removing the seal and the clip. I have done both but I cannot get this thing to budge. Has anyone else run across this? I have tried PB blaster to loosen things up, put the pully back on the shaft, put a piece of wood against the pully and tried tapping out with a hammer with no luck. I feel like it maybe something easy I am missing? Any help is appreciated in advanced! Thanks!