Engine won't turn over
- Thread starter 03mike
- Start date
Clicking is sometimes a bad starter solenoid. Usually if its a safety switch you get nothing.
Give us the model number (usually under the seat) so we can help you better.
and sometimes the battery can be bad and show a good charge, it just doesnt have enough amperage.
try putting the key in start position and check the voltage then, see if drops.
Give us the model number (usually under the seat) so we can help you better.
and sometimes the battery can be bad and show a good charge, it just doesnt have enough amperage.
try putting the key in start position and check the voltage then, see if drops.
Hello,
If the battery is old I'd replace it.
Had the same problem on my wifes Camry,,,replaced the battery and it was good to go. Voltage seemed good but it must have had a bad cell (low amperage).
An auto parts store should be able to test it for you, I hate replacing parts that I don't need to.
Regards
Jeff
If the battery is old I'd replace it.
Had the same problem on my wifes Camry,,,replaced the battery and it was good to go. Voltage seemed good but it must have had a bad cell (low amperage).
An auto parts store should be able to test it for you, I hate replacing parts that I don't need to.
Regards
Jeff
Hello,
You could. Sorry forgot to add an auto parts store should be able to check the starter motor if you care to remove it, this is what I did with the wife's Camry.
Sometimes with a bad starter, if you give it a rap with a wrench, it will work, signaling a bad motor winding. I doubt this test would detect a bad starter solenoid though.
Regards
Jeff
You could. Sorry forgot to add an auto parts store should be able to check the starter motor if you care to remove it, this is what I did with the wife's Camry.
Sometimes with a bad starter, if you give it a rap with a wrench, it will work, signaling a bad motor winding. I doubt this test would detect a bad starter solenoid though.
Regards
Jeff
bertsmobile1
Lawn Royalty
You check the solenoid by pulling the trigger wire (s) off the bottom and manually make a connection with some wires.
If there is only 1 trigger wire then connect a good ground to the base of the solenoid then jump form the battery cable to the other terminal.
Try it both with & without the auxillary ground contact.
If there is only 1 trigger wire then connect a good ground to the base of the solenoid then jump form the battery cable to the other terminal.
Try it both with & without the auxillary ground contact.