Export thread

engine swap

#1

S

spencerrubin222

Will an 18 hp briggs v twin fit in a 2010 craftsman lt1500 frame? the original engine was a 17.5 hp briggs


#2

B

bertsmobile1

spencerrubin222 said:
Will an 18 hp briggs v twin fit in a 2010 craftsman lt1500 frame? the original engine was a 17.5 hp briggs
Click to expand...
:welcome:
This is the best laid out specification pages for B & S
Look up your old engine and compare the dimensions with the new engine then go measure your mower.
V twins are longer than singles if the air filter is between the cylinders
V twins are wider than singles so it might foul on the hood
heights are almost the same
And you will need to buy new control cables


#3

S

spencerrubin222

bertsmobile1 said:
:welcome:
This is the best laid out specification pages for B & S
Look up your old engine and compare the dimensions with the new engine then go measure your mower.
V twins are longer than singles if the air filter is between the cylinders
V twins are wider than singles so it might foul on the hood
heights are almost the same
And you will need to buy new control cables
Click to expand...

I cant find anything online about the specs of the mounting holes. What control cables do I need to change? Will the original throttle cable work? Its just an offroad mower


#4

B

bertsmobile1

Sorry,
I was so busy double checking the data I forgot to post the link
https://www.smallenginesuppliers.com/html/engine-specs/briggs-engine-specs.html

There is a drawing of each engine under the description & photo complete with engineering drawing.


#5

S

spencerrubin222

bertsmobile1 said:
Sorry,
I was so busy double checking the data I forgot to post the link
https://www.smallenginesuppliers.com/html/engine-specs/briggs-engine-specs.html

There is a drawing of each engine under the description & photo complete with engineering drawing.
Click to expand...

I don't see the distance from one mounting hole to the other in the diagrams. They just show how tall they are and what the distance is from the center to either side. I just need to know if the mounting holes are going to line up.


Footer Links 1

Top