JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
Aug 2, 2023 #1
B
Butch Bridges
The e-clip is missing from the engine end of the push rod on my Poulan Pro PP19A42. I need to know the size so I can go to the hardware store and get another one.
Aug 2, 2023 #2
R
Rivets
Grab a caliper and measure the shaft. Subtract a 1/16” from your measurement and you have your size.
Aug 2, 2023 #3
Craftsman Garage
Grab a caliper and measure the shaft. Subtract a 1/16” from your measurement and you have your size.
read my mind
Aug 2, 2023 #4
StarTech
More likely it is a 8 mm push nut if no groove or a 6mm if there is a groove for it.
Aug 2, 2023 #5
B
Butch Bridges
I used an electronic caliper and it showed .09 inches. So is that like 1/4 inch or 3/8 inch or 7/16 inch or what?
Aug 2, 2023 #6
B
Butch Bridges
More likely it is a 8 mm push nut if no groove or a 6mm if there is a groove for it.
It has the grove
Aug 2, 2023 #7
R
Rivets
You need to remeasure as your reading is less than 1/10 of an inch.
Aug 2, 2023 #8
B
Butch Bridges
Thanks everyone for the help. I got a 1/4th inch e-clip and it worked!
Aug 2, 2023 #9
StarTech
Well 1/4 is fairly close to 6mm as 1/4 is 6.35mm.
