DLT3000 carb question

rainasdad

Forum Newbie
Joined
Jul 17, 2022
Threads
2
Messages
7
Im working on a fuel issue on this rider, it has a 18.5 hp Intek B&S single piston engine #31P777-0348E1
I need to clean up the carb, thinking old bad fuel. It wasn't getting fuel until I switched out the fuel pump with the one off my Gravley.
Once started you could smell the old fuel trying to burn-- wont stay running -
going to replace the fuel line, clean the tank, replace the fuel pump.
Any way , my question-- the bowl has a solenoid on the bottom of it, how do you remove the bowl for cleaning, as I dont see a bolt or hex nut holding it on?
Thanks for the help
 
Last edited:

StarTech

Lawn Royalty
Top Poster Of Month
Joined
Feb 19, 2020
Threads
75
Messages
10,110
The solenoid is separated from the fuel bowl using an open end wrench that has been thinned to fit between the solenoid.

The solenoid is holds the fuel on when you a Ruixing or Walbro. Nikki fuel bowl is held on by two screws.

Both the Nikki and Walbro uses a 13mm wrench and the Ruixing uses a 12mm wrench.
 
Top