Charging problem

[hlw49]

B+ terminal is on the right outside terminal of the regulator. At least it is on the FX600V engine I have where I replaced the engine on. Engine is complete runs but uses oil.

 

[tommag]

You guys have been a great help! That 6 pin connector is the main part of the problem. I say "main" because I'm still getting a little voltage but it's only 500mv full throttle, 200mv at idle. Since I don't have any Molex stuff, I by passed it with 14g wire for now. It's charging about 13.8v at idle now.
Thanks a bunch folks!