Briggs&Stratton 10.0 Genpower - No fuel

ILENGINE said:
OK looks like this is an older L head Briggs engine. The flat heads were bad for losing the valve clearances over time causing the valves not seat properly. May be time to remove the head, and the breather cover on the side and check the valve clearances. May have to remove the carb and air box to get access the breather cover.
Click to expand...
Thank you. Do you happen to know any solid resources where I can look up/find the proper valve clearances? Should this engine have a solenoid for the carb? Again I am appreciative.
 
Patch85 said:
Thank you. Do you happen to know any solid resources where I can look up/find the proper valve clearances? Should this engine have a solenoid for the carb? Again I am appreciative.
Click to expand...
Will need the numbers after the 19G412 from the engine to find the specifics as far as needing a fuel solenoid. Valves should be .005-.007 intake and .009-.011 exhaust
 
ILENGINE said:
Will need the numbers after the 19G412 from the engine to find the specifics as far as needing a fuel solenoid. Valves should be .005-.007 intake and .009-.011 exhaust
Click to expand...
After the model number on the engine is Type: 1187-E1. Followed by Code: 9909103A.
 
You must log in or register to reply here.
Back
Top