BR600 piston installation

[kaliona]

I am resealing the engine on this blower and want to be sure to install the piston correctly. How do I space the ring gaps relative to each other and relative to the crankshaft? Thanks for your help.

 

[StarTech]

Only need to be 120 degrees between end gaps. Arrow on piston faces exhaust port. Snap ring end gap for wrist pin either face up or down.

 

[kaliona]

Got it! Sounds easy. Thanks

 

[jp1961]

Hello,

I like to make sure the rings end gaps aren't in line with any machined ports (if possible), a mute point if the rings are pinned.

Regards

Jeff

 

[StarTech]

Kinda a mute point since it is a 4 mix engine. A 4 cycle non ported cylinder and not a 2 cycle ported cylinder.