Export thread

8 HP tecumseh chipper, replaced Carb, Fuel line, spark plug, it has spark, but STILL won,t start

#1

G

greenhouseguy

What else could there be?? I poured gas into the cylinder and best I could get out of it was a backfire no start and run partially and die .... nothing!


#2

upupandaway

upupandaway

"best I could get out of it was a backfire" That may be your problem. Take off the cylinder head and see if the valve(s) are closing. At Top dead center with both valves closed, try to turn the valve. if it easily turns, the valve is stuck open. If so, remove the valve, check the gap,grind down the valve gap down to spec as needed.


#3

G

greenhouseguy

upupandaway said:
"best I could get out of it was a backfire" That may be your problem. Take off the cylinder head and see if the valve(s) are closing. At Top dead center with both valves closed, try to turn the valve. if it easily turns, the valve is stuck open. If so, remove the valve, check the gap,grind down the valve gap down to spec as needed.
Click to expand...
OK at least I have something to try, I figured i would have to go deeper, now any tips to where I get the engine specs?


#4

Scrubcadet10

Scrubcadet10

You will need the model number, if it's a tecumseh flat head, it's usually stamped onto some sheet metal by the spark plug


#5

ILENGINE

ILENGINE

Had anybody checked the flywheel key to see if it is sheared. Wrong timing from sheared key will cause issues also.


Footer Links 1

Top