safety switch

  1. seagiant

    Snapper Safety Switch Problem!

    Hi, I have an older M281019BE Snapper RER. Trying to get it running again after buying it for cheap. Figure to go through it and fix what was needed. Had to replace some shot wiring and stayed with the old Harness and went by the Wiring Schematic, but... Having problems with 2 of the...
  2. P

    safety switch problem

    I can get my Husqvarna RZ5426 started. When i try to release the e-brake or move the steering arms my mower shuts off. Any help would be greatly appreciated. The steering arms are in the neutral position and when i release e-brake it wants to shut off.
  3. D

    Troy-Bilt Bronco 42" won't crank

    I have a Troy-Bilt 42" riding lawnmower, Model #: 13AK78BS011. It was working but the drive belt kept coming off when I would turn off the mower. When the PTO lever was not engaged, the belt looked extremely loose. I also have the belt retainers on close to the pulley. So I took the deck off and...
  4. C

    Safety Switch Problem Too

    I have a Z248F. After I start it up and move the levers in from the Park position the left arm being moved in causes it to shut off. I know that moving them both in simultaneously is what you have to do but I did notice that it’s the left arm by moving it in and out it reengages when moved out.
  5. L

    Safety switch problem on Husqvarna Z248F zero-turn mower

    I have a problem with a Husqvarna Z248F zero-turn mower. It's a 2015 model. When I move the steering levers inward with the seat occupied, the motor stops. It seems logical that the problem is probably with the safety switch under the seat. I've removed the seat switch and by using a...
  6. JoeZ

    PTO safety switch location

    Hello, anyone know where the PTO safety switch is located on a Cub Cadet LT 50 XT1 Model 13A0A1CZ056 Serial 1E149H20171 ?
  7. seagiant

    Snapper RER Safety Switch Problem!

    Hi, I have an older M281019BE Snapper RER. Trying to get it running again after buying it for cheap. Figure to go through it and fix what was needed. Had to replace some shot wiring and stayed with the old Harness and went by the Wiring Schematic, but... Having problems with 2 of the...
Top