oil

I have a John Deere LA135 Riding Mower which I bough used a few years ago. I have always used a Motorcraft FL910S Oil Filter on it due to a video I'd seen recommending them. I believe the recommended John Deere filer is a AM125424. I am wondering if anybody knows if there is any quality...

My mower has done 2 seasons domestic use with 13 hrs on the clock. It has HydroGear ZT3100 transaxles. Maintenance schedule says 100hrs to the first transaxle oil change but that would be 15 years away ! The other problem is that the mower was delivered with one of the reservoirs a bit low, and...

I located an oil leak in my transmission coming from behind the control lever. Looking at the parts diagram there are a couple o-rings behind the control lever and 2 pins that hold the control lever on transmission housing. Any help on how to remove those pins to free the control lever so i...

Transmission oil comes up thru steering column/

Been trying to change the oil in a sealed Hustler Raptor hydrostatic transmission. I'm using a oil suction pump but can only get 22 oz out. I'm using a 1/4 hose but can't seem to get it pushed lower into the unit. I'm going thru the fill port. Any ideas on what else I can try? 2017 raptor 52 inc

Hello I have a 1976 anniversary edition 4108, I rebuilt the engine and installed a cast iron sleeve. And an early 80’s 6211 that I engine swapped an opposed 19.5 hp Briggs into. Both run great and use very little oil. I was just wondering what you guys use for oil. As for me I use Phillips...

I have a Hustler Zero Turn with about 1500 hours on it and recently the Honda engine has been leaking some oil from the bottom in the area of the vertical shaft. I tried to include a photo, but apparently "it's too large to process". In any event, I am assuming a seal or gasket has failed...

Got this out from winter storage in the shed. New battery today . Engine starts but is hammering loud and blowing lots of oil & smoke out the exhaust. Dies after about 10 seconds. I bought it new over 25 years ago. about 700 hours on it. Oil changes & filter every couple of years. My guess is...

OK... I noticed that last time I mowed, that the mower was making a kind of clunking sort of noise intermittently. I use earplugs so I can't be more specific more than that. Today, it was doing it again. I tried with and without the front wheel drive power assist, because it SEEMED like it...

Grasshopper 616 Model with a Briggs model 356442, Type 0224-81, Code 090119. Is there any way to check the oil pump before I order a new one? Is there any specs. on the pump that I can get?

I have recently obtained a Hustler 295 Mower with a ONAN T260G engine. The Hustler has an oil pressure gauge which was a mechanical gauge, however, the oil tube was cut. I haven't been able to locate where the tube would have gone. Was there an oil pressure sending unit in the ONAN T260G? I'm...