briggs and stratton

I hope someone can point me in the right direction. I have a 900 Intek series 205cc (122012 0 140 B8) motor that I believe has broken the crank inside the case. It did not have a catastrophic failure; it was running fine. I shut it off and went to start it, and there was a clunking noise when I...

have a b&s model 44u877-0005-g1 serial number 180123yg : owner said was running good then heard a pop stopped mowing parked, did a compression check found both cylinders were 60 psi, one plug had a little moisture on it other was dry. i believe that the compression should be over 90 psi is that...

First, I'm not a mechanic - just a fairly handy homeowner. I hoping someone here might be able to help. I'm trying to fix my Husqvarna YTH24V48 riding lawn mower with a 44r877 Briggs and Stratton engine. The carb kit, oem part number 593392, works with the B&S "Chok-a-matic" system (which I...

Particulars: John Deere riding lawnmower, D140, 22hp Briggs and Stratton engine. the mower was started after sitting for a season, and with the throttle in the low speed position the engine revved up so high it sounded like it was about to explode. Shut it down, repeated the start process and it...

I have a craftsman mower with a briggs motor, 093j02-0011-f1, pouring white smoke out of the air filter breather tube. It is difficult to start as well. Any advice is greatly appreciated.

I have a mower with the above engine in it 2018 vintage, my problem is I can find numerous stamps and stickers on the engine but nothing that seems to relate to the model etc numbers. stamped on the exhaust is 595506. And on a sticker on the flywheel cover 17 0908 56 8126. my problem is when I...

My tow behind tiller uses a B&S #13l332-0001 E8 engine. After two seasons use the engine lost spark and would not start. I disconnected the kill switch wires and still had no spark. I bought a new #590818 coil from a B&S dealer and set it up (this side out) at about .010" from the flywheel. No...