brake

I just picked up a Toro Out Front Z model 78478. It's an old one, and one of the drives was replaced on the traction unit. Now, when I take the parking brake off, the unit wants to die. Can someone point me to documentation that can help me diagnose this problem and come up with a fix?

The old BBK brake pad wore out. I ordered a new brake arm with a new brake pad attached. I am trying to install the new arm but it is too tight against the brake drum and no seemingly room for the arm movement. Any idea of what I am doing wrong? Am I setting the arm's lower tension spring...

Hi, The Blu/Green, Liner, inside the Clutch/Brake Disc is gone, and going to replace it, but... Is it glued in, and if so, what is the best Glue???

RZ5424 about 15 ys old. Runs fine. Had a fuse blowing issue first. Which led to lots of new switches and parts thrown at it. Two things. Release brake engine stalls, engage pto engine stalls. Has to be a safety switch issue. Tested them all good. By passed seat switch. Engine runs well...

I know this topic was discussed on here before but maybe someone else might see it and know the answer. After removing the mower deck to replace blade and replacing on mower the mower will not start. I have traced the safety circuit to the PTO switch but cannot find where the brake switch is to...

Hadn't used my timecutter for a month and when I went out the battery was dead. I charged the battery and now the brake module just keeps running like it is engage/disengage parking brake but it isn't doing anything. It just hums/vibrates. Guessing that is why the battery was dead. I...

I have a Lawn Boy model 10304 self propelled mower that still runs great. But the cable that goes from the control bail to the engine (shuts off the engine when released) is broken. I can't seem to find one that looks like mine anywhere on line. The end of mine has a large pear shaped lead...

Have a problem on where rod hooks up on both ends one side to trans and other side to brake

Does anyone know how to get a stuck parking brake on a husqvarna yth22v46 to release? I have tried and it is locked on.

Hello everyone. Is there a trick to getting the free end of this little bugger thru the hole in the deck to anchor it. I can twist it around far enough but it seems too long. Maybe it's just a two man job. Any help would be appreciated!