Search results

This one is easy. I turn it in a my local Auto Zone. My local NAPA doesn't.

In my case it's two plastic plugs.

I updated my post. It's a Husqvarna 924HV MODEL 961930070 00. DOM 091911(2011) Thanks for pointing that out. I contacted Husqvarna to ask where to get Ronex ED 1. They are looking that up for me

Rivets, I checked. The manufacturer filled the gearbox with grease (Ronex ED #1) during manufacturing.

From the manufacturer's manual: AUGER GEAR CASE•The gear case was filled with lubricant to the proper level at the factory. The only time the lubricant needs attention is if service has been performed on the gearcase.•If lubricant is required, use only Ronex ED #1 My thought was to open the...

In our motorhome we use dryer sheets or moth balls.

How often should the gearbox grease be replaced? Husqvarna 924HV Model number 961930070 00 DOM: 091911 (2011) Since I have a 10 y/o snow blower when is it necessary? Owners manual implies only if gearbox has been repaired. The only reason I can think of to repair a gearbox is impact with...

I have a Toro Wheel Horse 8-25. Looking for a part number for an after market bagger that will bolt onto it. The OEM bagger is no longer available

The quantity of oil is still in question, the level of oil question I determined to be a broken (Dipstick) 15650-Z0L-000 Gauge Assy.- Oil Level. Which resulted in the owner over filling the engine by a lot.

What is the oil capacity for GCV160LAN N5R. Owners Manual states 12-13 oz Honda Website 18 oz Service Manual 18.56 oz Here is the link to Honda site I used for oil capacity https://cdn.powerequipment.honda.com/engines/pdf/manuals/00X37Z8B0023.pdf Here is identification sticker

I just acquired this and I am rebuilding it. Model 09584-0. I have the motor running but it is still too cold to test the compressor side. Not sure if it is a Generac or a Briggs & Stratton. Internet search for parts falls under B&S Does anyone have or know where I can get an owner’s...

I have a honda HRT2162TDA, the throttle lever does not to decrease engine speed in the slow position it seems to cause engine to stall. Are the high and low speed set screws adjustable? Anything I should do before I do this, Honda and Kohler do not make carburetor access easy!