Search results

Thanks for your reply. Yes, I know the flip-up has nothing to do with the gas gauge. I noticed that the gauge quit working while working on the flip-up problem, and I thought I would through that out there too. Thank you for the forum post about the gas gauge. If/When I figure out the flip-up...

Again, thank you for the schematic info. I found the breaker and engraved on the side it reads "short stop". I was optimistic this would be my problem but, I ran continuity across it and it checked out fine. It appears to be a one and done type of breaker. There was no reset on it. Could be a...

Thank you, This makes good sense. I did not know about that breaker. I checked all that I could see, and all checked out. I'll give this one a whirl and let you know.

My Flip up will not flip up anymore. I insert the pin in the lower switch on the deck rail, which kills the deck from moving as it should. I pull the lever in the back, which (dis)engages the other switch, and nothing happens. I took that switch out and ran a continuity check, which checked out...

Well last night I check to see if mower would flip up with the new battery and no go. So far I know its not the battery, not the switches. I can raise and lower the deck for cut heights just fine. Since I can raise and lower the cut height makes me think it would be the switches. The front...

That's a good point! I just replaced my battery and have not tried the flip up yet......I'll let you know how that goes

Thank you for your reply. Unfortunately, I am out of warranty. "Is deck lock pin in the service ( flip-up ) position?" If you mean...I pull the pin from its "hold" location and insert it in the lower slot with the ball switch. This kills the deck from moving up or down. Which it should. Then I...

Hello, I have the 48" Flip up from Hustler. It now has quit flipping up. Both switches appear to be working fine. When I insert the pin it kills the deck from moving up and down as it should. the back lever switch I took out and did a continuity test on it and it appears to be functioning...