Search results

Craftsman Tractor Model - 917.252510 - 42" Deck - 16HP Briggs Transmission Dana Transaxle Model - 4360.79 This thing is about 30 years old. The engine was blown when I received it (no oil), and previous owner has no history to help. It came with the house. Just completed an engine swap with...

Lt125(23420) - Too Fast!! This mower has the automated transmission with a forward and reverse pedal. No gear shift. I love it but in forward it easily goes too fast with just a light push on the pedal especially when trying to go slow mulching leaves. It is ok at first but the foot pressure...

Snapper Model number is 2690875, Serial number 2014719099 42" deck. I have found reference to two belt sizes, 91.10" and 94.45". My old belt is shredded so it is no help. The different belt sizes references one for a shallow groove pully and the other for a deep groove pully. How do I tell...

Tractor Model 2690872 Circa 2014 - I am looking for a mulch plate to fit onto my 42" deck to use for mulching leaves in the fall. I do not want to pay $160/$260 for a full mulch kit. Just looking to find only a plate to McGyver and make it fit the discharge on the deck. Any suggestions on one...

Running on one cylinder with both sides getting spark and fuel. When running the cylinder opposite fuel pump makes no change when pulling spark plug but engine dies when pulling plug wire on the fuel pump side. On the dead cylinder I removed the valve rocker cover and found both push rods bent...

I'm looking for a mulch plate for a 42" Snapper deck. I found a mulch kit that includes hardware etc. Has anyone used one of these on this site? Is it easy to remove the mulch plate, leave the hardware in place and side discharge?

I'm looking for a mulch plate for a 42" Snapper deck. I found a mulch kit that includes hardware etc. Has anyone used one of these on this site? Is it easy to remove the mulch plate, leave the hardware in place and side discharge?

Snapper LT125 with Briggs 23Hp Model 44L777 V-Twin. The cylinder on the brake side valve cover is much hotter to the touch than the other side. It runs fine but does exhibit some popping when the engine is shut off unless it is throttled to an idle first. Why would one valve cover be hotter...