Search results

Results 1 to 9 of 9
  1. J

    Kawasaki FX730V 26.0

    Received coils from Amazon installed them both, mower running great again!!! Thanks for all the help! Jim - jhm757
  2. J

    Kawasaki FX730V 26.0

    No not OE, but reviews of them are good and the price is right. I got a coil for my stihl chainsaw from Amazon, cost was about 1/4th cost of Stihl, been running it for years, no problems.
  3. J

    Kawasaki FX730V 26.0

    Found coils on Amazon, 2 for $35, should have them tomorrow and then will just replace them both.
  4. J

    Kawasaki FX730V 26.0

    Motor back together after adjusting valves both sides. All valves were .010 to .012 adjusted to .004, also pulled carburator and checked seemed to be all clean and good, reinstalled with new gaskets. Before this problem started I had ran both tanks to almost empty and then it took almost a full...
  5. J

    Kawasaki FX730V 26.0

    After valve adjustment compression didn't change. However I am using a compression tester that I have had for about 50 yrs and haven't used in about 30 yrs, when I retested the other side that had been at 100psi I now get about 80 on that side also. Do you think that one plug the BPR4ES on the...
  6. J

    Kawasaki FX730V 26.0

    I did pull the engine shroud and blew it out but it was pretty clean only a couple small spots of crud.
  7. J

    Kawasaki FX730V 26.0

    Valves on low compression side were at about .010 (didn't check the other side) adjusted them to .004 motor was cold, no increase in the compression. Something I noticed when I pulled plugs, (Had never checked them before cause it always ran great) Plug on the higher compression side was a...
  8. J

    Kawasaki FX730V 26.0

    Yeah I'm real good with Harley Shovelheads but I don't know much about these kawasaki's, I guess I need to get a service manual and start learning. I have never ran anything but 91 octane non ethanol in it since I have had it. Will try the seafoam, always ran it in my Mercury Outboard.
  9. J

    Kawasaki FX730V 26.0

    Bought a used Snapper Pro s200xt with the FX730V 26.0, it had 700 hrs when I got it and still less than 800, it has been running great for 2 seasons, but today it started running rough all of a sudden but then seemed to smooth out some, but has lost a lot of power. I checked compression and it...
Top