Search results

Not trying to simplify things but this actually sounds like a fuel problem. Drain the tank, drain the carb, put in new fuel adding some Sea Foam, about an ounce to the tank. Rock tractor to mix, wait ten minutes and start the engine. Has worked for me!

Get rid of that .155 line period. BTW: you are extremely wordy. Use recommended.105 or smaller line. .155 is for larger much more powerfuequipmant.

Thank you. I will check the engine number when I get home this afternoon and verify.

I don’t have it at present time but it is a 2016. Exh Family: GBSXS.1631VA

I have a Husqvarna AWD push mower with a B/S engine. 163cc and I have no manual. I need the spark plug number for this engine.

I have a ISX 2200 with a Kawasaki Ft730V-EFI and yesterday I ran one tank out of fuel. I switched to the other tank and restarted but began having problems with engine maintains full throttle. It will run for 15-30 minutes then will idle back down. Has done it several times. Anyone have any ideas?

It is white.

I have a 27 hp Briggs and Stratton Vanguard engine on my IS2100 Ferris Zero turn. Mowed with it last5 days ago and everything fine. Brought it home and unloaded off trailer and has been sitting until today. Started and noticed smoke from exhaust. Moved to pad, changed blades then moved to grassy...

I have an IS2100Z Series with 24x9.5-12 tires and looking at putting a bigger lug tire on because of slipping in wet grass and on hills. Recommendations? Can I use a 24x12-12 on this mower?

Which of these is the K3 and there is no green wire connected to either of the three.

The ignition light is lit but PTO light is not.

Star Tech, I have replaced PTO switch, bypassed the RIO switch, Bypassed the brake switch, and checked the new PTO switch with ohm meter and it is functioning properly. Getting up from computer now and going to buy a couple of cans of electrical spay to clean all contact and connectors.

I am still having issues and can't get pro to engage. Tried wiring straight to solenoid and solenoid is working properly when I put voltage direct to it. This morning I am not getting voltage from PTO switch to solenoid. Hav bypassed all safety switches, checked the PTO switch and it is working...

This will not help a it is just the operation manual and my problem is well past overheating of engine.

Thanks for the advice. I am thinking along with you that it is more than likely the solenoid. I do have a Tech manual and it is a big help.

The battery is fully charged and as far as I can determine no bad connections. This machine has a hydraulic PTO not electrical.

I have checked fuses, switch is functioning properly. I even by-passed all safety switches and still no PTO. It started a few weeks ago intermittently going out and after running forward for a few feet it would come on but when I started backing up and lifting on switch it would quit again. Now...

Serial #:M0X485A033030 X485 Tractor

I have a John Deere X485 Lawn tractor and my PTO will not engage.