Search results

I have a cub cadet zero turn mower with a kholer kt735 spec 3013 motor which, I've just changed the head gasket on. the cylinder now has 150 lbs of compression. the other cylinder has 125lbs of compression. I've set the valve clearance at 5 thousands at top dead center. the 125lb cylinder plug...

I have a kt735 spec 0005g1 that is surging bad. I've set the valve clearance, new plugs, new oem (walbro) carb. I checked compression and one cylinder has 125 lbs and the other has 97 lbs of compression. does this indicate a blown head gasget? can there be any other issues?

I have a john deere mower la140 with a brighs 23 hp motor model 445577 v twin. I replaced a defective head with a new one, set thelash at .007 1/4 past top dead centerif i pull the plug wire while running on the new head tjere's no change in rpms. if i pull the plug wire on the opposite head it...

I worked on a troybuilt power drive push mower and on the shield on top of the engine, says add oil, butdont change? I change the oil on all my mowers each spring. Has anyone seen any mower that tells you don't change the oil???

I'm working on a cub cadet zero turn with a 25hp kholer twin engine. When i engage deck the mower loses power. I checked the coils, and one was not firing. I bought an after market coil, put it on the engine and hooked up the kill wore that goes from the key swotch to both coils. One coil cuts...

Onan 24 hp twin cylinder verticle shaft. Gas spitting out top of carb when cranking to start. New carb, so float is not stuck. What can cause this?

on the convertable mower what is the blue wire from the key switch for?