Search results

model 13AX11CH712 Deck belt jumps off on lowest setting. All the pulleys seem to be ok. I did notice the belt runs high on the tension pulley. Anyone out there in Cub land have any issues with this model. Thanks for any help

thought i would post an update on the old Gator with the Kawasaki KF82D-x engine. After much testing and searching found a Club Car CDI module #1012520 that would replace Kawasaki part 316670-2002. Hope this may help someone out in the future.

look at partstree 4 a listed under alternators all will fit. First one on left side in attached picture 474B is yellow plug

You could use the charging system from the 16HP engine if it is a Briggs engine by replacing the charging stator and the voltage regulator. I have used these two with success. 10 to 16 amp charging system. Notice the yellow plug on stator matches the yellow plug on the voltage regulator and the...

Trying to help a friend with a problem on an old Gator utility vehicle. The engine is a Kawasaki KF82D-x that does not have a spark at plug. The engine has an exciter coil behind flywheel and another coil mounted under flywheel metal shroud. Anyone that could give me any help troubleshooting...

Looking for a wiring diagram for sears 917.288520 any help will be great. Thanks much

anyone use seafoam to clean carbon

I use one of these from Harbor freight. After I get it raised I use a safety chain.

PM sent

I will need to do more research and get back with you. It was past on to me from FIL. Tomorrow I will get the model number and the Briggs and Stratton number from the engine. after more research I could not find year manufactured with pony serial number. The Briggs engine was manufactured in...

the pony I have has 2 belts one for forward and one for reverse

Look on the tube from transmission to the tines for model number

looking at the cam for this engine the compression release located at lower section of cam near the gear if it has broken it will not release compression. I am not a mechanic maybe some one with more knowledge can chime in.

Helping a friend out with the Pto not engaging. There is no voltage at pto connector under engine. Replaced pto switch and nothing. Any help would be appreciated.

Hello new member looking for help with Briggs v twin Intek running on one cylinder. Has compression and spark. Any help would be great. Thanks in advance.