Search results

The other option now that I'm thinking of it would be to just order a bigger size, then see if I can adjust the output shaft pulley size to compensate.

Pulley takes 1/2" belt Currently measures 2.25" OD, and 1.35" in the base of the groove. If the bore size was increased to 1-1/8", then it would only leave a inner wall thickness of around 0.11". Once the key is cut out from it, there would be pretty much no wall left.

The problem that I ran into is that my pulley is 2.25" OD, they do not make them for a 1-1/8" shaft. There would not be enough material left if pulley was bored out. There is a 2.5 listed in the catalog, bit seems like they are not available anywhere I have found. This would be pushing it...

I picked up this 8hp industrial plus Briggs engine as a replacement for my brush mower. Good running engine. When swapping it out, found this one has a 1-1/8" shaft size, and my 1" pulleys won't swap over. Does anybody know what these were used for, or if these are in demand? First one I have...

Hi, I have a 60" Z Master with a 30hp motor. I purchased a new set of gator g6 blades, which are 3" wide. However, when I go to change the blades, I see the spindles have a lip on the bottom that allows it to only fit 2.5" blades. This is the first time i've run across this. Picture below to...