Search results

I've got a Cub Cadet 2165 tractor (136-268-100) with the BDU-10 trans and about 1000 hrs. Over the years, the hydro dipstick started loosing friction, so I wrapped a bit of electrical tape around it. That worked well for many years, but I'm in the process of changing the fluid and filter and...

I've got a stupid question on cleaning a carburetor in an ultrasonic cleaner. I'm considering getting one and was wondering... I've seen dozens of videos where they just drop it in, but aren't there a lot of air pockets in there? I always think to myself that they should spin it around after...

I've got a Radius E with the 708 Loncin 136-7817 engine. It's got 100 hours on it and I want to check valve lash. I'd rather not pay for two new gaskets before knowing if I need them. Do these usually come of cleanly? What's a good (and cheaper) alternative to the OE gaskets? Also, from my...

Hey all, I see in a lot of videos people using a wheel on their drill to to clean carbon off heads and to remove old gasket material. I've seen some use a nylon cup brush, but a lot use what looks like a pad of some sort. What do you use? And is WD-40 enough? Thanks.

I was doing routine maintenance on an old White Chipper/Shredder/Vac with a Tecumseh HM90 engine that I haven't used in years (tank has been dry). I peaked into the fuel tank and saw what's in the photo. This may have been in there forever as far as I know. The tank is gray plastic and is in...

Hey all, I've got an H35-45593S engine on a Troy-Bilt Junior tiller that seems okay at idle and half throttle, but hunts a bit at full throttle. I don't use this thing much and it hasn't run well for several years. I did replace the carb a while ago after cleaning the old one didn't help. No...