Search results

Hey all, I have a FS120 that i wanted to swap out the ignition coil of . It is one with bull horn handles & throttle/start/stop slider switch on right handle.When removing old coil the kill switch wire DID NOT go up the shaft to the slider switch but instead terminated under engine block.Upon...

G'day guys, Further to my prior posts regarding electrical issues on my Toro zmaster 6000, it was suggested the new ignition switch i purchased may be the wrong one. I think the issue is more complex than that but hoping icould get verification from wiser folk here as to whether this switch's...

G'day gang, Yes I now fully agree my last posted question re: 'how to hotwire' my Toro ride-on was foolish & not well thought through. Possibly bordering on sacrilegious to some members. Panic & lack of knowledge got better of me & no disrespect intended. So.... I'm hoping...

hey guys, as title states , my regard is for info of how i go about hotwiring my toro that bypasses ignition plug. ignition module is unplugged from a good plug on the lume. if i " loop 'a' to 'b' & run a direct cable from 'c' to 'd' " is the type of info i'm hoping for please. cheers

Hey guys, Never had issues with starting the Z & then bugger me done few laps other day & pulled up to answer phone /slash . Jumped back on & "clunk" ! Thought I'd forgot 1 of the safety's as that's the sound it made. No. All gd. & should've started but "clunk".Wiggled wires , bounced on seat...

G'day fellow slashers from Sunny Aus. Have just joined after going goggle eyed via you tube vids trying to suss out the proper procedure for replacing bearings on my $ earner. I've read the operator manual & the additional docs. to do with these spindles & am still at a loss as to the proper way...