Got new controller installed and it works fine. The old controller gears were locked up and wouldn't allow the motor to move the brake arms.
Thanks for all your help!
So the wire harness is one piece for everything then and not just the controller? (121-5652)
If so, I think I'll just change out the controller if the harness connector plug to it looks clean.
Thanks Star Tech!. I checked the continuity of the seat switch and the mower engage switch and they are good. Was going to check the Single pole safety switches on each arm but was pretty sure they are probably good too. I assume the control module unplugs from the harness without special...
I have a toro MX5060 zero turn. Twice now it has powered off when I move the handles to the neutral position and will not restart. The first time I let it sit for a while, checked the battery for voltage which was okay, pulled the seat safety switch plug off and blew it clean, plugged it back...